Tower of Strategic Mechanics

Write the first paragraph of your page here.

Section heading[]

ascending, half-descending tower in Ring 6. Made by blender_cxii. It shares the "tower in a tower" structure of Tower of Inception, but unlike it, it isn't two steeples side by side. This tower should be completed after the Thanos Tower or Tower of Thinning Layers, or even Tower of Confusion!

Pro's Guide[]

Starting the Tower[]

Layer 1A: It starts with the jump booster section. Then there are three morpher sections. There are often ordinary jumps, in & out jumps and wraparounds. In the first two you have 10 seconds to beat and in the last 20 seconds. At the end of the floor there are a few normal jumps. You will be at floor 2 for a short time now. After some normal jumps there is an outside section that has one long wraparound-like jump to the first layer. You can make a wallhop between the two layers' walls. The beginning to this section is similar to the beginning of the short second floor section. Then there is a button that activates two pushing platforms. And then after two long jumps there is a ladder to the next layer.
Layer 2A: At the start two jumps with tightrope at the end. The first is a jump to the letter L and the second jump is a long diagonal jump. Then there is a tightrope leading to the wall climbing section. Make this section and you will climb the ladder. Then there's a 10-1 stud wraparound and a difficult section with beatbricks that has a L-Jump, a long diagonal jump and a few simple jumps (it is not written in order.). Then three jumps with a tightrope at the end. The first is a headhitter to the corner, the second is a jump to the lower located 5x1 brick and the third is a long diagonal jump. Then there is a tightrope leading to the pushbox section. If you fall on the red floor, make a corner wall glitch or 11 stud high jump. Go to the end of this section and you will find two buttons. Press the smaller one and come back to the beginning of this section. You will find a purple 4x4x4 cube. Push the cube along the track that has 90° turns and a gap at the end. Press the button with the cube and return. You will notice the purple obstacle course, which has only basic jumps, but one of the jumps is a very long jump (Fortunately, it has been nerfed.). A few jumps and there will be a windmill. After the windmill, two 1x1x1 stud bricks and you will find yourself on the third layer.
Layer 3A:
Layer 4A: Almost the entire floor contains memorybricks. There are various jumps and wraparounds. Pay attention, that you can easily get lost.